University of Wollongong
Browse
DOCUMENT
theses_830_1.pdf (325.07 kB)
DOCUMENT
theses_830_2.pdf (3.7 MB)
1/0
2 files

Low-velocity pneumatic transportation of bulk solids

thesis
posted on 2024-11-18, 14:52 authored by Bo Mi
Low-velocity pneumatic conveying is being used increasingly in industry to transport a wide range of bulk solids due to reasons of low power consumption and low product damage, etc. However, investigations into this type of conveying still are at an elementary stage. For example, the existing procedures to estimate pipeline pressure drop during low-velocity pneumatic conveying still are inaccurate and inefficient. For this reason, this thesis aims at developing a pressure prediction model that is a function of the physical properties of the material, pipeline configuration and conveying condition. During low-velocity pneumatic conveying, particles are conveyed usually in the form of slugs. This thesis studies initially the pressure drop across a single particle slug and the stress state and distribution in the slug through theoretical analysis. To obtain detailed information on low-velocity pneumatic conveying, a test rig is set up and four types of coarse granular material are conveyed in the rig. Major parameters such as mass flow-rate of air and solids, pipeline pressure, slug velocity and wall pressure, etc. are measured over a wide range of low-velocity conveying conditions. Based on the experimental results and a dimensional analysis, the relationship between the slug velocity and superficial air velocity is established in terms of the physical properties of the material and pipe size. Also by using particulate mechanics, a semi-empirical correlation is developed to determine the stress transmission coefficient for the slugs flowing in the pipe with rigid and parallel walls. A model then is developed to predict the overall horizontal pipeline pressure drop of low-velocity pneumatic conveying. This model is used to predict the pneumatic conveying characteristics and static air pressure distribution for different test rig pipelines and materials. Good agreement is obtained between the predicted and experimental results. Based on the developed model, a method for determining the economical operating point in low-velocity pneumatic conveying is presented. Additional experimental results from the conveying of semolina show that the performance of fine powders is quite different in low velocity. Based on these experimental results, an appropriate modification to the model is made so that it can be applied to the prediction of pressure drop in low-velocity pneumatic conveying of fine powders.

History

Citation

Mi, Bo, Low-velocity pneumatic transportation of bulk solids, PhD thesis, Department of Mechanical Engineering, University of Wollongong, 1994. http://ro.uow.edu.au/theses/830

Year

1994

Thesis type

  • Doctoral thesis

Faculty/School

Department of Mechanical Engineering

Language

English

Disclaimer

Unless otherwise indicated, the views expressed in this thesis are those of the author and do not necessarily represent the views of the University of Wollongong.

Usage metrics

    Categories

    Exports

    RefWorks
    BibTeX
    Ref. manager
    Endnote
    DataCite
    NLM
    DC