Global and Local Corrosion of Welded Joints of High-Strength Low-Alloy Automotive Steel
journal contribution
posted on 2024-11-17, 12:56authored byMainã Portella Garcia, Juliana Sarango de Souza, Carol Glover, Phil Ansell, Geraint Williams, Gerson Luiz Mantovani, Ramachandran Vasant Kumar, Renato Altobelli Antunes
Global and local corrosion techniques were used to study the corrosion behavior of weld joints of a high-strength low-alloy steel (LNE500) typically used in the automotive industry in Brazil. The welded joints were prepared by gas metal arc welding. Two welding transfer modes were used to obtain different heat inputs: pulsed (PUL) and cold metal transfer (CMT). Local and global corrosion analysis techniques presented complementary information. While the local in situ analysis (scanning vibrating electrode technique) revealed the weld metal (WM) as the region where corrosion started, conventional electrochemical techniques (potentiodynamic polarization [PP] and electrochemical impedance spectroscopy [EIS]) revealed a higher corrosion rate in the coarse-grained heat affected zone, which was preferentially corroded. A superior corrosion resistance of the WM obtained using CMT over the PUL transfer mode was revealed by EIS and PP. In addition, the results from CMT and PUL samples show that the austenite grain size affects the propagation of the corrosion process. The results are discussed based on microstructural and compositional aspects of the different regions that characterize the welded joints.